- Reduced price
- New
SAE MAM2261
$98.00
$44.10
Save 55%
SAE MAM2261 Revision D, July 1, 2007
Tolerances, Metric Nickel, Nickel Alloys, and Cobalt Alloy Bars, Rods, and
Wire
Description / Abstract:
This specification covers established metric manufacturing
tolerances applicable to bars, rods, and wire of nickel, nickel
alloys, and cobalt alloys ordered to metric dimensions. These
tolerances apply to all conditions, unless otherwise noted. The
term "excl" is used to apply only to the higher figure of a
specified range.
Throughout this specification, the term "metric" is intended to refer to the SI system. These tables are based upon logical metric values and preferred metric sizes.
Where the terms "nickel", "nickel-copper", "nickel-chromium", "nickel-molybdenum", "nickel-molybdenum-chromium", and "cobalt" are used without qualification, they refer to both non-heat-treatable and heat-treatable alloys as applicable, unless otherwise noted.
AMS 2261, specified in inch/pound units, is the equivalent of this MAM.
Throughout this specification, the term "metric" is intended to refer to the SI system. These tables are based upon logical metric values and preferred metric sizes.
Where the terms "nickel", "nickel-copper", "nickel-chromium", "nickel-molybdenum", "nickel-molybdenum-chromium", and "cobalt" are used without qualification, they refer to both non-heat-treatable and heat-treatable alloys as applicable, unless otherwise noted.
AMS 2261, specified in inch/pound units, is the equivalent of this MAM.
SAE MAM2261 Revision D, July 1, 2007
Tolerances, Metric Nickel, Nickel Alloys, and Cobalt Alloy Bars, Rods, and
Wire