- Reduced price
- New
SAE MAM2262
$98.00
$44.10
Save 55%
SAE MAM2262 Revision D, September 1, 2007
Tolerances, Metric Nickel, Nickel Alloy, and Cobalt Alloy Sheet, Strip, and
Plate
Description / Abstract:
This specification covers established manufacturing tolerances
applicable to sheet, strip, and plate of nickel, nickel alloys, and
cobalt alloys ordered to metric dimensions. These tolerances apply
to all conditions, unless otherwise noted. The term "excl" is used
to apply only to the higher figure of a specified range.
Where the terms "nickel", "nickel-copper", "nickel-chromium", "nickel-molybdenum", "nickel-molybdenum-chromium", and "cobalt" are used without qualification, they refer to both non-heat-treatable and heat-treatable alloys as applicable, unless otherwise noted.
Throughout this specification the term "metric" is intended to refer to the SI system. These tables are based upon metric values and preferred metric sizes.
AMS 2262, specified in inch/pound units, is the equivalent of this MAM.
Where the terms "nickel", "nickel-copper", "nickel-chromium", "nickel-molybdenum", "nickel-molybdenum-chromium", and "cobalt" are used without qualification, they refer to both non-heat-treatable and heat-treatable alloys as applicable, unless otherwise noted.
Throughout this specification the term "metric" is intended to refer to the SI system. These tables are based upon metric values and preferred metric sizes.
AMS 2262, specified in inch/pound units, is the equivalent of this MAM.
SAE MAM2262 Revision D, September 1, 2007
Tolerances, Metric Nickel, Nickel Alloy, and Cobalt Alloy Sheet, Strip, and
Plate