- Reduced price
- New
SAE USCAR-15
$78.00
$35.10
Save 55%
SAE USCAR-15 3rd Edition, February 1, 2010
SPECIFICATION FOR TESTING AUTOMOTIVE LIGHT BULB SOCKETS
Description / Abstract:
This specification establishes the requirements and test
procedures for automotive miniature bulb retention devices,
including wedge base sockets with integral connector, direct wire
wedge base sockets, circuit plate assemblies, and associated
interfaces.
Tests shall follow the sequence shown in the flow charts in Appendix E whenever the following occurs:
•New design
•Design, material or process change made to an existing device, which could affect the outcome of the test.
The test sequence shown in Appendix F shall be run annually.
(NOTE: Production process control data collected at a shorter interval per an approved control plan, may be substituted if approved by customer's responsible engineer and purchasing representative.)
Tests shall follow the sequence shown in the flow charts in Appendix E whenever the following occurs:
•New design
•Design, material or process change made to an existing device, which could affect the outcome of the test.
The test sequence shown in Appendix F shall be run annually.
(NOTE: Production process control data collected at a shorter interval per an approved control plan, may be substituted if approved by customer's responsible engineer and purchasing representative.)
SAE USCAR-15 3rd Edition, February 1, 2010
SPECIFICATION FOR TESTING AUTOMOTIVE LIGHT BULB SOCKETS